Advantages and Disadvantages of Each Specification of Aluminum Heat Reflect Fiberglass Hose

Many people don`t know the specifications of Aluminum Heat Reflect Fiberglass Hose, what are the functions of Aluminum Heat Reflect Fiberglass Hose, the advantages and disadvantages of various specifications of Aluminum Heat Reflect Fiberglass Hose, and there are many Special Material Braided Sleeve suitable for sealing products. Hydraulic system, among which the Aluminum Heat Reflect Fiberglass Hose is one of the Special Material Braided Sleeve. It is often used to seal the piston in the hydraulic system of automobiles, as well as other hydraulic devices and hydraulic cylinders.

The product quality of Special Material Braided Sleeve directly affects the performance of the equipment. Due to different sealing media, Aluminum Heat Reflect Fiberglass Hose of different materials can be used. The Aluminum Heat Reflect Fiberglass Hose belong to the Special Material Braided Sleeve on the lips. Category, there are low lip and high lip. The traditional production process of Special Material Braided Sleeve is mainly molding. The current more advanced process is to use turning equipment. The process is simple and the yield rate is high. This is also the most advanced method at present and can produce very precise Y-shaped Special Material Braided Sleeve.
The main disadvantage of the Aluminum Heat Reflect Fiberglass Hose is that it can only work in one direction. The bidirectional sealing of the piston type requires the use of a pair of Aluminum Heat Reflect Fiberglass Hose, which increases the axial size. The cross-sectional size of the ordinary Y-shaped Special Material Braided Sleeve is larger than Special woven sleeves, so the size of the installation groove is larger. In order to facilitate installation, split grooves are sometimes needed. Now many countries have developed Special Material Braided Sleeve with small cross-section sizes, and the size and installation problems are gradually improving.
The role of Aluminum Heat Reflect Fiberglass Hose is mainly reflected in the piston rod or piston seal in the hydraulic cylinder. The sealing of the Special Material Braided Sleeve can be divided into two pressure conditions. When there is no medium pressure, it only relies on the pre-compression amount of the lip. It comes close to the Special Material Braided Sleeve to play a sealing role. When there is medium pressure, the medium will fill the groove between the inner lip and the outer lip, pushing the pressure on the two lips respectively, causing the two lips to expand. Open further, and then close to the sliding parts, so when installing the Aluminum Heat Reflect Fiberglass Hose, the cavity must be installed facing the medium.
Silicone Special Material Braided Sleeve manufacturers would like to remind you that the maximum working pressure that the Special Material Braided Sleeve can withstand is around 20Mpa. When the pressure exceeds this value, the support ring can be assisted to fix it to increase the pressure. Special woven sleeves also have a certain self-compensation ability to cope with gradual wear and tear during use.
Therefore, Aluminum Heat Reflect Fiberglass Hose is suitable for sealing medium and low pressure reciprocating motions. Such as piston and cylinder, piston rod and piston cover, etc. It mainly relies on the lip to be close to the surface to be sealed to achieve a sealing effect. Therefore, the sealing lip tip is prone to wear and heat deformation. Therefore, the lip size is the focus when surveying and designing, including the outer diameter, inner diameter of the lip, the amount of pre-compression and clearance of the lip, etc.