Analysis of the causes of joints in silica gel fiberglass pipes

1. The raw material tube of Silicone Glass Fiber Tube has joints, and the raw material manufacturers of glass fiber tube are uneven. According to the raw materials learned by the editor, 46% of the glass fiber tubes are defective, which leads to the failure of silicone glass fiber tubes. There will be joints in the finished product;

2. During the painting process of the silicone glass fiber tube blank tube, the semi-finished product of the silicone glass fiber tube will be defective, which requires scissors for the defective section of the casing, and a new joint will appear;
3. Testing, the testing standards for silicone glass fiber tubes are defined differently by each manufacturer, which also leads to some inconsistencies in the joints. For example, if the length of A is 100 meters and is tested twice, it is necessary to cut a section every 50 meters for testing. The rest are connected to form a joint;
4. For the joints that appear when the silicone fiberglass tube is packed, the excess needs to be cut off for a roll of 100 meters, and then connected to another silicone fiberglass tube to make up a full 100 meters for packing;
How to avoid or reduce the occurrence of joints, of course, is to improve the quality of raw materials, improve process requirements and reduce the number of inspections of silicone glass fiber tubes.
1. The transportation of the product; under normal circumstances, the sleeves of high-quality glass fiber tube manufacturers are carefully packaged, so be careful during the handling process, no matter whether the glass fiber tube is a new production or a used product. Handle without thread protectors; in order to avoid damage to the product, use appropriate fastenings to ensure safe loading, and avoid bending of the glass fiber tube as much as possible.
2. Product loading and unloading: Before unloading, it should be confirmed whether the thread protector is left on the pipe end and the condition of the glass fiber tube, and when loading and unloading the casing, one by one is loaded and unloaded separately, and it is forbidden to damage the pipe body And brute force loading and unloading of threads. Neither can the fiberglass pipe be dragged directly from the loading truck, nor can the pipe be rolled down the track. The correct way is to use woven cloth or a cloth belt type lifting ring to complete the unloading.
3. Storage conditions of glass fiber tubes; there are special requirements for the storage of glass fiber tubes. It is not suitable to stack them directly on the ground, on rails or on steel frames. They should be staggered at the bottom of the casing and between layers. Therefore, it is possible to effectively prevent the joints of the pipes from bearing large loads. When the glass fiber tube is placed on the support bar, appropriate wooden blocks should be nailed at both ends of the support bar to prevent the tube from sliding or shifting. The glass fiber tube should not be stacked at an excessively high position for easy inspection and loading and unloading.
Paying attention to the above three factors is a necessary condition for the glass fiber tube to maximize its value. Just like a good horse with a good saddle, a good product also needs high-quality staff to use it to make the best use of it. Only in this way, In order to create greater value for enterprises and society.