Can Neoprene Velcro Cable Sleeve be used for cables and lighting lines?

Neoprene Velcro Cable Sleeve is used as automatic instrument signal line protection tube Stainless steel hose is used to protect precision optical ruler and sensing line; it has good flexibility, corrosion resistance, high temperature resistance, wear resistance, tensile resistance Stretch and water resistance. It also provides some shielding effect. Can braided conduit be used for cables and lighting lines? Of course it is. What should be paid attention to when threading with Cable Sleeve.

The conductors used for neoprene Velcro cable glands should be rated for a voltage greater than the operating voltage of the line. The insulation of the wires should conform to the installation method of the line and the environmental conditions of the laying. The cross-section of the wire should meet the requirements of power supply and mechanical strength. When wiring, try to avoid wire joints, because accidents are usually caused by poor wire ends. Connectors must be crimped and soldered. Connections and branches of conductors shall not be subjected to mechanical forces. In no case shall the wires running through the ducts have any joints. If necessary, place the connectors in the junction box or lamp head box as much as possible.
Before laying the Neoprene Velcro Cable Sleeve, the following inspections should be carried out, the bracket should be complete, the paint should be complete; the cable type, specification, and voltage should meet the design requirements; the cable insulation is good. The power cables used in the three-phase four-wire system shall not use three-core cables plus single-core cables or conductors, and the cable metal sheath shall be used as the neutral wire. The single-core cables used in the three-phase system should form a tight triangular arrangement and should be fixed with cable ties every 1m. Power cables running in parallel should be of equal length.
When laying Neoprene Velcro Cable Sleeve, spare lengths should be reserved at the terminal heads and intermediate joints. There is a small margin for the entire length of the straight section, and it is laid in a wave shape. The bending radius of the cable shall not be less than 20D. The cable should be led out from the upper end of the drum to avoid friction and dragging of the cable on the bracket and the ground. Unremoved cables shall have no mechanical damage.
The Neoprene Velcro Cable Sleeve and the control cable should be arranged separately; when the power cable and the control cable are laid on the same side of the bracket, the control cable should be laid under the power cable. After the cable is laid, the debris should be removed in time and the cover should be covered. If necessary, cover joints should be sealed to avoid intrusion of water, steam, oil, dust, etc. When the cables pass through the pipe, each power cable should pass through a pipe alone, but the AC single-core power cable must not pass through the steel pipe alone. The selected wires should meet the design requirements; the wires should have no kinks, dead bends, insulation damage, etc.; when connecting and stripping the insulation layer, the wire core should not be damaged, and the joints should be wrapped with insulating tape, which should be uniform, tight and not low than the original dielectric strength.