How can I use Nomex Braided Sleeve for a long time?

The instructions for use of Nomex Braided Sleeve are the same as those of ordinary Special Material Braided Sleeve. It can be expanded to 200%. If your equipment is 3MM in diameter, then you can use a flat-width Nomex Braided Sleeve, which is suitable. It saves materials and is beautiful. If you don`t want to break the position, just use a lighter to melt it.

Generally speaking, there are two reasons for the short service life. One is the hardness of the organic matter, and the other is damage caused by soft friction of different levels during the high-precision slurry filtering operation. For this In both cases, how should we maintain it so that it can be used for a longer period of time?
1. If the hardness is too high, due to the high hardness, the friction will definitely be a lot, which will cause damage. In addition, when the mesh and the Special Material Braided Sleeve rub, it will cause a lot of small holes. This At that time, the method we used was to increase the thread pitch of the Special Material Braided Sleeve, and then choose products with high hardness materials, so that they could be used longer.
2. We can raise the rubber rings on the edges during the screening process to reduce the friction of the Special Material Braided Sleeve. Generally speaking, the stress-bearing points are in the center. Therefore, use a 5cm eraser pad to separate them in the center, which is convenient. It will reduce the forced friction between the special woven sleeves and the lining mesh. Simply reducing the friction in the center can extend the service life of the mesh tube by more than 3-5 times.
The manufacturer of Special Material Braided Sleeve first analyzes that Special Material Braided Sleeve are woven from nylon yarn. Nylon yarn is a general term for thermoplastics rich in repeated amide groups on the molecular carbon chain, including alicyclic PA, human fat-fat Among them, alicyclic PA has many types, large production volume, and wide application. Its name is determined by the number of single actual oxygen atoms produced.