How can we make PET Self Wrap Braided Sleeve last longer?

Open Type Braided Sleeve manufacturers first analyze that PET Self wrap braided sleeve are crocheted from nylon yarn. Nylon yarn is a general term for thermoplastics rich in repeated amide groups on the molecular carbon chain, including alicyclic PA, human fat -Alicyclic PA and alicyclic PA. Among them, alicyclic PA has many types, is produced in large quantities, and is widely used. Its name is determined by the number of individual oxygen atoms produced.

①High softness, good ductility memory ability, and bending recovery force;
② Better resistance to chemical changes, stain resistance, and wear resistance;
③Able to withstand high temperature sterilization while working under continuous high temperature;
④Low water absorption;
⑤It is not easy to cause the surface layer to fall off.
The instructions for using PET Self Wrap Braided Sleeve are the same as ordinary Pet Self Wrap Braided Sleeve. It can be expanded to 200%. If your equipment is 3MM in diameter, then you can use a flat-width PET Self Wrap Braided Sleeve, so suitable, saving materials and beautiful appearance. If you don`t want to break the position and loosen it, just use a lighter to melt it.
Generally speaking, there are two reasons for the short service life. One is the hardness of the organic matter, and the other is the damage caused by some different levels of soft friction during the high-precision slurry filtration operation. For these two situation, how to maintain it so that it can be used for a longer period of time? Let`s take a look at the methods recommended by this website for you:
1. If the hardness is too high, due to the high hardness, the friction will definitely be a lot, which will cause damage. In addition, when the mesh and the Open Type Braided Sleeve rub, it will cause a lot of small holes. At this time, the method we use is to increase the thread pitch of the Open Type Braided Sleeve, and then choose products with high hardness materials, so that they can be used longer.
2. We can increase the edge rubber ring during the screening process to reduce the friction of the Open Type Braided Sleeve. Generally speaking, the stress-bearing points are in the center, so use a 5cm eraser pad to separate them in the center, so This will reduce the forced friction between the Open Type Braided Sleeve and the lining mesh. Simply reducing the friction in the center can extend the service life of the mesh tube by more than 3-5 times.