How do I install an Open Type Braided Sleeve joint?

Open Type Braided Sleeve may be in a normal linear state when used, or in a true curved state, or more complex depending on construction needs, so in this case, the Open Type Braided Sleeve may be in a normal linear state when properly installed . in use. It may be in a real bending state, or it may be more complicated according to the construction needs. In this case, how to install it correctly and what things need to be paid attention to in order to avoid installation errors. In order to facilitate everyone's construction, we have summarized the correct installation of winding open-style braided sleeves. The following points!

1. There are strict regulations on the bending radius value of winding Open Type Braided Sleeve, because when the bending radius is (5-10)d, the shape of the wave mainly depends on the change of the groove and flange radius. When the bending radius is small (5-10)d, residual deformation occurs not only in the wave form of the corrugated bending belt, but also in the wave form of the straight bending belt. Under these conditions, Cable Sleeve tubes were destroyed after multiple deformation cycles.
2. The influence of the installation state of the plastic winding braided network pipe on the laying of the Open Type Braided Sleeve can be straight or curved. The length of the Open Type Braided Sleeve used in the equipment, regardless of the type of Open Type Braided Sleeve installation drawing, should specify the middle section H, whose value is H=(2~3)d, which is used to prevent flexibility in the embedded joint Parts are excessively deformed and easily damaged. The fatigue strength of the insert is reduced due to the load on the corrugations near the insert of the joint, and the residual thermal stresses induced by the welded or brazed end fittings. Practice has proved that the most frequently damaged parts of the Open Type Braided Sleeve are here.
(1) Dimensions The nominal diameter of the Cable Sleeve pipe, the choice of joint type, the size of the Open Type Braided Sleeve and the length of the Cable Sleeve pipe.
(2) According to the actual working pressure of the braided network pipe, check the nominal diameter and pressure gauge of the corrugated Open Type Braided Sleeve to determine whether to use the stainless steel mesh sleeve Open Type Braided Sleeve.
(3) The chemical properties of the conveying medium in the medium braided network pipe determine the material of each part of the braided network pipe according to the corrosion resistance of the braided network pipe material.
(4) Temperature The working temperature and range of the medium in the braided network pipe and the ambient temperature when the braided network pipe is working. At high temperature, the temperature-corrected pressure should be determined according to the working pressure and temperature correction coefficient of the high-temperature Open Type Braided Sleeve to determine the correct pressure level.
(5) According to the use state of the Cable Sleeve pipe, refer to the correct use and installation method of the open-type braided sleeve and the length of the Cable Sleeve pipe in settlement compensation, calculate the length, number of small bending times and small bending basis of the Cable Sleeve pipe in various motion states Braided network pipe radius and other factors, the correct selection and installation of braided network pipe length parameters.