Introduction to methods to delay the service life of Pattern Braided Sleeve

The use method of knitting is the same as ordinary knitted sleeves. It can be expanded to 200%. If your equipment is 3MM in diameter, then you can use a flat-width knitted sleeve to support it. This is suitable, saves material and looks beautiful. Be generous, if you don't want to break the position and loosen it, just use a lighter to melt it.

Generally speaking, there are two reasons for the short service life. One is the hardness of the organic matter, and the other is damage caused by different levels of soft friction that often occur during high-precision slurry filtration operations. For these two In this situation, how should we maintain it so that it can be used for a longer period of time? Let’s take a look at the Pattern Braided Sleeve manufacturers:

1. Operation method with too high hardness. Because the hardness is relatively high, the friction will definitely be a lot, which will cause damage. In addition, when the mending mesh and the Pattern Braided Sleeve rub, it will cause a lot of small holes. This At that time, the method we used was to increase the thread spacing of the Pattern Braided Sleeve, and then choose products with high hardness materials, so that they could be used longer.

2. We can increase the edge rubber ring during the screening process to reduce the friction of the Pattern Braided Sleeve. Generally speaking, the stress-bearing points are in the center. Therefore, use a 5cm eraser pad in the center to separate them, which is convenient. It will reduce the forced friction between the Pattern Braided Sleeve and the lining mesh. Simply reducing the friction in the center can extend the service life of the woven mesh tube by more than 3-5 times.