PP Zipper Braided Sleeve production steps and techniques

PP zipper braiding sleeve is a craft of weaving thin wires or ropes into an open Braided Sleeve shape, used to package and protect wires or pipes. The steps to make it are relatively simple, but require a certain amount of skill and patience. The following editor will introduce the steps and techniques for making PP Zipper Braided Sleeve.

1. Prepare materials and tools To make Open Type Braided Sleeve, you need to prepare the following materials and tools:
Braided thread: Threads of various materials can be used, such as cotton thread, nylon thread, etc. Choose the appropriate wire according to your needs.
Knitting tools: Knitting machines, knitting needles and other tools can be used to assist in knitting. If you don't have special tools, you can use common needles and zippers instead.
2. Measure and cut the wire. First, you need to measure and cut the wire to the appropriate length according to the length and diameter of the pipe. The length of the wire should be slightly longer than the length of the pipe so that the PP zipper can still be connected after being braided.
3. Weaving up and down
Tie a knot in a section of wire as a starting point for braiding. You can use a needle and thread to sew the ends of the wire to make it stronger.
Thread the wire through the hole in the braiding tool, aligning one end of the tool with one end of the pipe. Then, slowly move the tool through the entire pipe by pulling on the wire until you reach the other end.
Once you've reached your target location, remove the wire and tool from the Open Type Braided Sleeve and secure the other end of the wire to prevent it from slipping out.
4. Knit left and right
Secure one section of the wire, then thread the other end of the wire through the hole in the braiding tool and insert it from the other side of the Open Type Braided Sleeve.
Make sure the wire and tools are inside the Open Type Braided Sleeve and thread the wire from one side of the Open Type Braided Sleeve to the other in the same manner.
Repeat the above steps until the entire wire is braided into the shape of an open braided sleeve.
5. Finishing treatment
Pull the ends of the wire tight and sew using a needle and thread to make it stronger.
Check that the Open Type Braided Sleeve are even and flat. If there are sagging or pilling areas, you can use stitching to secure them.
You can use scissors to trim the ends of an open braided sleeve.
Before braiding, you must ensure that the length of the wire is sufficient and the size is appropriate to avoid causing trouble in subsequent operations.
When knitting, you need to keep your hands steady and use even pressure to avoid unevenness or inconsistent tightness in the Open Type Braided Sleeve.
The tightness of the braid can be adjusted as needed. If you want the Open Type Braided Sleeve to be tighter, you can increase the tension; if you want the Open Type Braided Sleeve to be looser, you can reduce the tension.
Different colored wires can be used to PP Zipper Braided Sleeve to increase the decorative effect.
During the finishing touches, the quality of the Open Type Braided Sleeve needs to be carefully checked and any necessary trimmings made.
All in all, knitting Open Type Braided Sleeve is a simple and fun craft activity. Just prepare your materials and tools, follow the correct steps and techniques, and you can create beautiful braided Open Type Braided Sleeve that provide protection and decoration for wires or pipes.