Precautions for using Neoprene Velcro Cable Sleeve

The pressure bearing capacity of Neoprene Velcro Cable Sleeve mainly depends on the inner layer and the middle braided layer (polyester reinforcement layer). If it is improperly assembled during use, it will cause airflow to enter the middle layer between the inner layer and the outer layer. At this time, the hose is mainly compressed by the outer layer, which will cause the pressure bearing capacity of the Neoprene Velcro Cable Sleeve to drop significantly, causing the tube body to burst (the burst in this case is often the outer layer is damaged, while the inner layer is intact).

If the Neoprene Velcro Cable Sleeve uses a jacket-type quick connector or a threaded connector/throat clamp with burrs or burrs, it may cause the Neoprene Velcro Cable Sleeve tube body to be disassembled and ruptured.
We can see that when the jacket-type quick connector is used to insert the Neoprene Velcro Cable Sleeve, it is mainly sealed by the outer layer. In this case, gas is easy to penetrate from the middle layer, causing the outer layer to burst and the tube body to be disassembled.
Try to avoid using jacket-type quick connectors that are sealed by the outer layer for Neoprene Velcro Cable Sleeve.
If the outer layer of the Neoprene Velcro Cable Sleeve is found to be broken or the tube body is delaminated during use, please check whether the jacket-type quick connector is used and whether the connector and the hose clamp have burrs.
If you want to use a jacket-type quick connector, it is recommended to use a single-layer Taurus head PU tube if the pressure allows.
1. When inserting the threaded connector, please do not apply grease or heat it with fire on the threaded connector of the hose. Please heat the hose with a little warm water before assembly;
2. Please use a connector suitable for the diameter of the hose, cut the cut and try to insert the hose. Be careful not to use connectors with burrs, burrs, scars, or rust;
3. Please use a hose clamp of appropriate size, and do not use a low-quality hose clamp with burrs;
4. Avoid using iron wire instead of a hose clamp to avoid over-tightening the hose.
5. Do not use a jacket-type quick connector for the Neoprene Velcro Cable Sleeve, otherwise it will easily cause the hose to be disassembled and burst.