Problems and Suggestions Encountered When Using Automotive Wiring Harness Protection Sleeve

The Automotive Wiring Harness Protection Sleeve is used as a carrier for liquid, gas and other materials to circulate and cover.

1. There are bubbles inside and outside the wall of the protective sleeve of the automobile wiring harness. There may be the following reasons for such a situation
①The problem of raw materials: The raw materials are impure, have impurities or mixed with air, which may cause bubbles in the protective sleeve of the Automotive Wiring Harness Protection Sleeve, and in severe cases, the tube wall will rupture.
②Production process problems: Unqualified quality management control and immature industry will cause defective Automotive Wiring Harness Protection Sleeve.
③External environment: Whether there is the influence of ultra-high temperature object gas, whether there are splashing sparks and chemical substances, etc.
2. The car wiring harness protective cover turns yellow, yellows, and becomes sticky
①If it is used for too long, it is normal for the exterior to turn yellow, and the interior can be cleaned with high temperature and acid and alkali to keep the interior clean and hygienic. problem, so it is recommended to replace the good quality Automotive Wiring Harness Protection Sleeve that meets the requirements in time.
②There is stickiness on the outside of the Automotive Wiring Harness Protection Sleeve. Check whether the external environment is affected by special substances, and whether the internal delivery material is within the delivery range. If there is none, it may be a quality problem with the Automotive Wiring Harness Protection Sleeve. It is recommended to replace it in time.
3. Storage matters
①Should be sealed and stored to prevent rain and sunlight exposure
② Avoid contact with condensation-type Braided Sleeve and special chemicals
4. Use according to the parameter requirements of the Automotive Wiring Harness Protection Sleeve, and cannot be used subjectively.