Reasons for wire breakage in PET Velcro Braided Sleeve

Pet Velcro Braided Sleeve are well known to the public as a product that is widely used now, but I don`t know if you have experienced the phenomenon of PET Velcro Braided Sleeve having broken wires. If the PET Velcro Braided Sleeve we use have broken wires If there is a phenomenon, there may not be any major problems in the near future, but as time goes by, adverse reactions will slowly occur. So what is the reason for broken wires in PET Velcro Braided Sleeve?

1. The size adjustment of the mold on the machine is wrong. During the Open Type Braided Sleeve process, the normal compression ratio will be confused and the thread will be broken. The solution is to ensure the absolute size of the mold on the machine.
2. The oil or water is cut off during the mold loading process, causing the mold to enlarge the hole spacing in a short period of time, causing the compression ratio to be out of balance, resulting in wire breakage. The solution is to add lubricant to each mold in time to ensure its cooling and lubrication.
3. When wicker threads appear during the Open Type Braided Sleeve process, and the take-up speed is too fast, the PET Velcro Braided Sleeve will have broken threads. The only solution is to replace the mold to ensure that the wicker thread phenomenon will not happen again.
4. A certain piece of the mold consumes too much natural energy, causing the front and rear compression ratio of the PET Velcro Braided Sleeve to be out of balance, causing broken wires to appear. This is mainly manifested as several broken wires at one location. The solution is to replace the mold and adjust the front and rear compression ratios, until normal.