The function and correct use of the Automotive Wiring Harness Protection Sleeve

Automotive Wiring Harness Protection Sleeve are widely used in electronic products. The function of Automotive Wiring Harness Protection Sleeve is mainly to transfer heat through gaps, and play the role of insulation, shock absorption and sealing. However, due to improper use by some customers, it is not only useless to achieve the desired effect, but also damages the Automotive Wiring Harness Protection Sleeve. What should be paid attention to when using the Automotive Wiring Harness Protection Sleeve?

1. The surface of the protective sleeve of the automobile wiring harness should be kept clean to avoid sticking to dirt, which will lead to poor self-adhesiveness and thermal conductivity of the seal.
2. When picking up a heat-conducting Automotive Wiring Harness Protection Sleeve with a large area, it should be grasped from the center, because the large Automotive Wiring Harness Protection Sleeve is unevenly stressed, which will cause deformation and affect subsequent operations.
3. When using, you should hold the sheet with your left hand, and tear off one side of the protective film with your right hand. Do not tear off both sides of the protective film at the same time. It is necessary to reduce the number and area of direct contact with the protective cover of the automotive wiring harness to ensure that the self-adhesiveness and thermal conductivity of the protective cover of the automotive wiring harness are not damaged.
4. Tear off one side of the protective film, facing the radiator. Align the car harness protective cover with the radiator and lower it slowly. Be careful to avoid the generation of air bubbles. When tearing off the protective film on the other side and putting it into the radiator, the force should be small, so as not to strain or pull up the protective cover of the car wiring harness.
5. If air bubbles are generated during operation, you can use tools to gently wipe out the air bubbles, but the force should not be too large, so as not to damage the heat-conducting Automotive Wiring Harness Protection Sleeve. You can also pull up one end of the car harness protective cover and repeat the above steps to perform the operation again.
6. After tightening or using a strong adhesive Automotive Wiring Harness Protection Sleeve, apply a certain amount of pressure to the radiator and store it for a period of time to ensure that the Automotive Wiring Harness Protection Sleeve is fixed.