The real way to remove the smell of Heat Shrinkable Tube

Recently, I have seen many people reacting to why Heat Shrinkable Tube produce odors or even odors. The main reason is that the Heat Shrinkable Tube are produced after the reaction of accelerators and vulcanizing agents. Therefore, some Heat Shrinkable Tube manufacturers choose a relatively suitable one for this purpose. additives, or if there are odorous products, add appropriate chemical additives to react them.

Most manufacturers will choose flavors, odor masking agents, deodorants, adsorbents, and even combustion methods; however, these additive products are not deodorizing, they just cover up the taste; flavor deodorants are ineffective. Covering odor masking agent, and using it will have two disadvantages:

1. Produce a new and stinkier smell
2. Rebound. Over time, the flavor comes out again because the essence evaporates.
There are also some domestic adsorption deodorant products. I believe that everyone has done experiments or used such products, so I won`t go into details about their effects. Anyway, it doesn`t really remove the smell of Heat Shrinkable Tube.
Therefore, the key to truly removing the odor of Heat Shrinkable Tube lies in the selection of raw materials for Special Material Braided Sleeve and the vulcanization system and process.
3. Silicone Heat Shrinkable Tube raw materials and production and processing: Often some silicone Heat Shrinkable Tube product manufacturers add a certain proportion of Heat Shrinkable Tube in order to reduce costs, and also add a certain proportion of polluting operating oil; however, these must be environmentally friendly This can only be achieved with operating oil that is odorless and has the ability to inhibit and degrade polluting volatiles in Heat Shrinkable Tube recycled materials, and the cost will not be cheap. Therefore, if we want to fundamentally solve the smell of Heat Shrinkable Tube, we must choose the raw materials and production and processing of Special Material Braided Sleeve. For example: choose oil with high flash point and odorless; do not add recycled rubber; do not use accelerator CBS; do not use DCP, etc. Recommendation: Special Material Braided Sleeve foam material
4. Vulcanization system and process: The Special Material Braided Sleeve are made of gas phase glue, which is mixed with an odorless vulcanizing agent. The Special Material Braided Sleeve are formed after secondary vulcanization (the recommended secondary vulcanization time is more than 4 hours, the temperature is about 200 degrees, and it is a vacuum oven) .)