What are the measures to prevent static electricity when producing Automotive Wiring Harness Protection Sleeve?

In daily life, we all know that friction can generate electricity. When producing Automotive Wiring Harness Protection Sleeve, direct friction between Automotive Wiring Harness Protection Sleeve and human clothing can generate static electricity. Static electricity will bring some safety hazards. The following editor will introduce the measures to prevent static electricity when producing Automotive Wiring Harness Protection Sleeve.

1. For processes and equipment sites with electrostatic hazards, corresponding electrostatic safety measures must be adopted, and the electrostatic potential of the insulator should be controlled below the allowable value.
2. In areas where explosive gases may appear, ventilation measures shall be strengthened to keep the concentration below the lower explosion limit.
3. Where there is danger of explosion and fire and where the human body is protected from electrification, the operator must wear anti-static overalls, anti-static shoes or conductive shoes. Conductive ground should be laid in the operating area, and the resistance value of the conductive ground to the ground should be lower than 10Ω, and its conductivity must always be maintained.
4. The main procedures and static safety measures for the production of Automotive Wiring Harness Protection Sleeve are:
(1) Rubber mixing: An ion flow static eliminator should be installed when using an open rubber mixing machine for plasticizing raw rubber, pressing insulating rubber materials, and re-milling gasoline Cable Sleeve film.
(2) Heat refining: When an open rubber mixing machine is used for insulating hot mixing rubber, an induction static eliminator should be installed at the place where the film is taken out.
(3) Manufacturing of Cable Sleeve: When using flammable solvents to manufacture Cable Sleeve, the following measures must be taken:
① Cable Sleeve manufacturing machinery should adopt gear transmission as much as possible. When V-belt transmission is used, an anti-static V-belt must be selected. If ordinary V-belt transmission is used, its surface conductivity must be improved, and regular inspections must be carried out to maintain its conductivity.
②The stripping of the adhesive film on the barrel wall of the cable bushing must be kept away from areas with explosion and fire hazards, and the action should be light and slow.
③ It is strictly forbidden to use the pump to spray the solvent directly into the mixing barrel of the Cable Sleeve, and the self-flowing method must be adopted.
④ When manually inserting rubber strips, transporting the Cable Sleeve and uncovering the cover or cover of the Cable Sleeve, the action must be light and slow. It is strictly forbidden to use insulating materials for the covering.