What is the basis for judging that the Automotive Wiring Harness Protection Sleeve is not familiar

Manufacturers of Automotive Wiring Harness Protection Sleeve have encountered that after the Automotive Wiring Harness Protection Sleeve is formed, the appearance and function cannot meet the required product requirements, resulting in a large number of defective Cable Sleeve, resulting in a waste of resources. This situation is generally due to the incomplete vulcanization of the rubber of the Automotive Wiring Harness Protection Sleeve, resulting in the product being unfamiliar. So in the face of the unfamiliar problem of Automotive Wiring Harness Protection Sleeve, how should we judge? What is the basis for judgment? How to avoid such problems from happening.

1. Overall unfamiliarity: The temperature of the forming mold is too low or the vulcanization time is too short, resulting in the overall softness and stickiness of the Automotive Wiring Harness Protection Sleeve after molding. When touching this kind of bad product, there will be a slight sticky feeling. Use your nails to pinch the surface Will leave nail marks.
2. Unfamiliarity inside: When the Automotive Wiring Harness Protection Sleeve is formed, the temperature, exhaust and discharge methods are adjusted, so that the product that needs a certain period of time to be vulcanized can be released from the mold in advance. The inside of the product is not completely vulcanized, which affects the use of the product and causes a waste of resources. This situation generally occurs on larger solid products.
3. Partial unfamiliarity: This situation generally occurs on the substrate of the Cable Sleeve button and the inclined wall of the load. After the product is molded, the appearance and function of most parts can meet the product requirements, but there is unvulcanized raw rubber in a small part of the part.
In short, when producing Automotive Wiring Harness Protection Sleeve, we must pay attention to the molding mold temperature and curing time of Automotive Wiring Harness Protection Sleeve. We cannot shorten the molding and curing time in order to improve production efficiency. This will not only fail to improve production efficiency, but also cause waste of manpower and material resources.