Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
First of all, most of these belt marks come from the production process of Stainless Steel braided sleeve. Why do you say that? It is because some Stainless Steel Braided Sleeve manufacturers are missing a step in the process. After molding, there is usually a high-temperature oven to vulcanize the Stainless Steel Braided Sleeve with cross-linking factors. The temperature of this step is much higher than the temperature in the drying tunnel, which allows the Stainless Steel Braided Sleeve to undergo a preliminary shaping, that is, the Stainless Steel Braided Sleeve. The surface is basically crusted and mature, but the Cable Sleeve tube inside the wall thickness is not fully vulcanized, so the drying tunnel needs to be vulcanized again, so that there will be no belt marks if an oven is added between the drying tunnel and the extruder, because The surface of the Stainless Steel Braided Sleeve has been solidified, so even if it is placed on the conveyor belt, there will be no belt marks!
As for the problem of belt marks, it is the absence of the oven process, which will cause this problem on the surface of the Stainless Steel Braided Sleeve, because the Stainless Steel Braided Sleeve immediately enters the conveyor belt of the drying tunnel for vulcanization after being extruded from the die mouth. , note that the surface of the stainless steel braided casing is not vulcanized at this time, and it is still in the state after the Cable Sleeve is drilled, but the threaded rod is pushed out of the mold mouth (at this time, the Cable Sleeve is soft and will be left behind by some external stimulation) Traces) and the conveyor belt of the drying tunnel is not replaced every day. With the continuous aging of the conveyor belt or continuous incompleteness and adsorption of dust, at this time, the Stainless Steel Braided Sleeve will immediately appear after the conveyor belt. It is the source of the belt marks. If the belt marks have been formed in the front drying tunnel, the post-baking tunnel cannot change the surface of the Stainless Steel Braided Sleeve, so this will happen after molding.
October 16, 2024
October 15, 2024
October 16, 2024
October 15, 2024
Email to this supplier
October 16, 2024
October 15, 2024
October 16, 2024
October 15, 2024
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.