What is the reason for the lack of elasticity of the Automotive Wiring Harness Protection Sleeve in the process?

If you don't pay attention to the Automotive Wiring Harness Protection Sleeve in the molding process, some bad phenomena will appear. For example, Cable Sleeve products have poor elasticity. However, some frequently used cable bushings have certain requirements for tensile toughness, and the product mainly needs its tensile toughness to maintain. Therefore, in some manufacturing industries, once the Cable Sleeve material used in the machinery industry has insufficient tension, the rebound and shock absorption will fail, and other performances of the product will be useless. Therefore, the operation of personnel, the modulation of the machine and the coordination of raw materials in the molding process are the keys to the toughness and failure of the product.

For raw materials, ordinary Cable Sleeve will have some problems, such as substandard service life, poor toughness, and insufficient rebound. In addition, adding too much silicone oil and white carbon black to the raw materials of the Cable Sleeve leads to confusion in the performance of the product, the silicon atoms in the silicone resin are destroyed, the softness is reduced, and stickiness occurs, and the softness and fluidity are not good, resulting in high temperature molding. The tensile strength of the product decreases, and the product will not be reflected after the production is completed, but after a period of use under the conflict of various environments, the product will gradually deform, the rebound rate will decrease, and the product will become sticky.
The debugging and cooperation of the machine in the molding process of the Automotive Wiring Harness Protection Sleeve has a certain influence. Sometimes in the vulcanization process, in order to increase the output and increase the production efficiency, the staff shorten the vulcanization time and the products released from the mold will appear soft. When the output is reduced, the temperature must be increased to reach a certain balance rate, otherwise the product will have various adverse phenomena, and if the production time is too long, the product will be too brittle and will be torn if it is stretched. It is recommended that during the production process Properly control the product time and vulcanization temperature.
In short, in the production process, there will be no quality problems in the toughness of the Automotive Wiring Harness Protection Sleeve except for several factors such as machine, raw materials, man-made, and the environment. Therefore, the Automotive Wiring Harness Protection Sleeve manufacturer controls these factors in the production process. , There will be basically no problems with the quality of the product.