What is the treatment method for Nylon Braided Sleeve after use?

All Nylon Braided Sleeve are mostly treated in the same way. They must be strictly sterilized before they can be used. Then the sterilization method and sterilization temperature must be known. Because this kind of pipe is different from other products, the sterilization temperature is a key point.

No matter what type of Braided Sleeve product, it can be sterilized using +250℃ (+482℃F) hot air or +135℃ (+275℃F) steam at a pressure of 3.5bars. The sterilization time is 1.5 hours +135℃ ( +275℃F), the short time interval after a disinfection is one hour to restore the Cable Sleeve to a stable state. Steam will change the organic matter and expansion properties of the silicone elastomer. The braid should be carefully inspected after the accumulation time of steam disinfection exceeds 150 hours. Whether the sleeve can continue to be used, the pipe fittings will become effective after the recommended disinfection life is exceeded.
Failure to operate in accordance with the usage specifications will cause adverse conditions. We will not be responsible for improper use of Cable Sleeve, but the user must provide the high PH value and working temperature of the transmission material. In addition, we do not recommend the use of silicone tubes for transmission. Abrasive products.
Even if the tube does not contain a silicone sealing ring, the Cable Sleeve cannot withstand rolling pressure. Rolling pressure will cause the internal objects to be disassembled, causing high voltage in production and damaging the Cable Sleeve. Therefore, in order to avoid damage to the Cable Sleeve, the installation Use within the temperature specification parameter range. A Cable Sleeve cannot be used as a rope. Do not use it to pull or drag anything, and avoid dragging the Nylon Braided Sleeve on the ground.
If it is not used temporarily, we should wash it, sterilize it through a Braided Sleeve, and then put it on a dry shelf to avoid exposure to sunlight and ozone, in order to avoid placing it in chemicals. We should use 45℃ or 90℃ to bend the head and tail of the interface to ensure that no dust or harmful substances enter the pipe.