What issues should be paid attention to when using Tinned Copper Braided Sleeve?

1. The bending radius should not be less than the given bending radius to prevent damage to the Special Material Braided Sleeve frame or premature damage due to over-extension.

2. According to the conditions of use, correctly select the variety and specifications of Special Material Braided Sleeve, and do not use them incorrectly or substitute them.
3. When using Tinned Copper braided sleeve, the pressure should be adjusted evenly and slowly to avoid damage to the pipe body due to a sudden increase in pressure.
4. When the working location changes, it should be moved off the ground and not mopped to avoid scratching the outer rubber and corroding the skeleton layer.
5. When transporting corrosive liquids, the inside should be cleaned after use to prevent residues from corroding the pipe body for a long time, or use corresponding series of products.
6. First of all, start with visual inspection. The wall thickness of poor-quality Special Material Braided Sleeve is uneven, the steel wire weaving is too tight or the number of layers is too few. The Special Material Braided Sleeve will deform greatly when they are slightly stressed, and are prone to rust. The glue layer and the steel wire layer are adhered. If the force is insufficient, these conditions will make the pipe wall prone to bursting.
7. Secondly, improper selection of the crimping amount and crimping speed when assembling the Tinned Copper Braided Sleeve and the joint, or unreasonable selection of the structure, material, and size of the joint can lead to the Special Material Braided Sleeve and the joint being too tight or too loose, causing early damage to the joint.