What should be paid attention to when producing Automotive Wiring Harness Protection Sleeve?

The Automotive Wiring Harness Protection Sleeve is a flexible tube made of silica gel with different properties according to the power and conveying material of the Cable Sleeve. The Automotive Wiring Harness Protection Sleeve is required to meet the standard of medical-grade Automotive Wiring Harness Protection Sleeve, and the tube is required to be odorless to meet food and drug standards, without obvious bubbles, impurities, and black spots, otherwise the Cable Sleeve will rub against bubbles or black spots during work. If the cover is worn out, what should be paid attention to when producing the Automotive Wiring Harness Protection Sleeve?

First of all, when producing Automotive Wiring Harness Protection Sleeve, it is necessary to keep the production environment clean, and avoid pollution sources and other adverse factors that affect the completeness of the vulcanization of Automotive Wiring Harness Protection Sleeve, so that impurities or incomplete vulcanization of Automotive Wiring Harness Protection Sleeve will cause air bubbles, which will eventually affect automotive wiring harnesses. The use of a protective case.
Secondly, before kneading silicone rubber, the rollers of the mill must be cleaned again, and must not touch water, oil, sweat, etc.
In addition, the size of the Automotive Wiring Harness Protection Sleeve must be within the tolerance range during production, and the precision of the size directly affects the flow rate of the Cable Sleeve when it is working. Therefore, during the production process, operators need to always pay attention to whether the protective cover of the automotive wiring harness is stretched or bent, and take samples to measure the size of the protective cover of the automotive wiring harness every 100 meters of production. If there is a significant change in the specification, a solution must be taken immediately.
Finally, after the extrusion production of the Automotive Wiring Harness Protection Sleeve is completed, it must be vulcanized in two stages to avoid stickiness and frosting of the Automotive Wiring Harness Protection Sleeve, thereby ensuring the safety of the Automotive Wiring Harness Protection Sleeve.