What should I do if the Silicone Glass Fiber Tube is damaged from the edges and center?

There are generally two situations that cause damage to the Silicone Glass Fiber Tube. One is that the strength of the material is very high and the friction caused by the Silicone Glass Fiber Tube is relatively high, causing the Silicone Glass Fiber Tube to be damaged. The other is not repairing the mesh. The friction with the Silicone Glass Fiber Tube will make the Silicone Glass Fiber Tube produce many small round holes, causing the Silicone Glass Fiber Tube to be damaged from the edges and the center.

1. The mesh number of the filter mesh of the silicone glass fiber tube is determined by the pore diameter and wire spacing. At this time, we need to ensure that the pore diameter remains unchanged and increase the wire spacing. Furthermore, we must use strong silicone. Glass fiber tube, so that the silicone fiberglass tube will not grind the mesh screen in a short time.
2. It will often appear in the process of filtering highly detailed slurry. It is common that during the process of sifting pottery slurry, the Silicone Glass Fiber Tube is often damaged from the edges and the middle, because it is used to filter pottery slurry. The mesh number of silicone glass fiber tube filters is very high and the price is also very expensive. Therefore, saving silicone glass fiber tubes actually means saving production costs.
We raise the rubber ring on the edge of the screen frame, so that the friction of the silica glass fiber tube on the edge becomes soft friction. In addition, the center of the silica glass fiber tube generally has a large bearing capacity, which means that the silica glass fiber tube in the center is in contact with the lining. The friction of the mesh is serious, and the screening effect of this area is just poor, so we use rubber pads to separate the 5cm in the center of the silica glass fiber tube, so that the silica glass fiber tube is in contact with the lining mesh and the edge of the Silicone Glass Fiber Tube. The mandatory friction is reduced, and tests have confirmed that the service life of Silicone Glass Fiber Tube can be increased by 3 to 5 times.
The corrosion resistance of the Insulation Tubes depends on the chromium content. When the chromium content is added to 10.5%, the gas corrosion resistance of the steel can be significantly enhanced. However, when the chromium content is higher, although the corrosion resistance can still be improved, it will not. Obviously, the reason is that when steel is fine-grained and strengthened with chromium, the type of surface hydroxide is changed to a surface hydroxide similar to that produced on pure chromium metal materials. This tightly adhered chromium-rich hydroxide Maintain the surface to prevent further oxidation. This oxide layer is thin, and the natural smoothness of the surface of the Insulation Tubes can be seen through it, giving the Insulation Tubes a smooth surface. Moreover, if the surface is damaged, the exposed steel surface will be in contact with the air. The chemical change performs its own maintenance, forming this coating again, and once again plays a protective role.