What tips are needed for Tinned Copper Braided Sleeve installation?

In our renovation project, hydropower transformation is a very important link, which is related to our electricity safety. In the decoration construction project, safety must be the first priority. Let's take a look at the skills required for the installation of Tinned Copper braided sleeve, and what we need to pay attention to during the installation process.

1. Tinned Copper Braided Sleeve installation skills
① 25mm by 20mm minus 25mm by 30mm Tinned Copper Braided Sleeve, a fixed point in the installation of Tinned Copper Braided Sleeve should have at least two normal pipe screws and arranged horizontally.
② For wire ducts with a size of 25mm x 30mm or more, there should be at least three fixing screws at a fixed point, and they should be installed in a trapezoidal shape, so that the stress points of the Tinned Copper Braided Sleeve can be more dispersed.
③ Except for the fixed point, two holes should be drilled every one meter or so, and then passed in with twisted-pair wires. After the wiring is completed, all the twisted-pair wires should be bundled together.
④ If the Tinned Copper Braided Sleeve is installed on the wall surface, the distance between the fixed points of the wire groove is generally one meter, which can be divided into two types: nailing screws directly into the cement and nailing screws with plastic expansion tubes first.
⑤ The way of hammer trunk line or horizontal wiring is the same, one is horizontal and the other is vertical.
2. Precautions for installation of Tinned Copper Braided Sleeve
① When installing the Tinned Copper Braided Sleeve, be careful not to cause cracks on the wall and not to damage the wall structure. When laying, it should be changed according to the number of penetrations in the pipe. In the same tube, there should not be more than four wires. It is forbidden for the wires to occupy all the space in the tube, because this is not conducive to the normal operation of other lines.
②The distance between the power line and the telephone line and TV line should be greater than 50 cm, and the pipeline and structure should be fixed. , All switches and sockets should be installed with junction boxes. If the pipeline bends or is too long, a junction box should be installed at a certain distance. There should be no wire joints in the pipeline, and it should be played out in the protective tube of the wires. A pipe bending tool should be used to keep the wires from wrinkles, so it should be configured reasonably according to the specifications.
③In the installation and construction of the Tinned Copper Braided Sleeve, the pipeline should be installed first, and then the wire should be threaded, so as to avoid the phenomenon that the wire cannot be twitched when the wire needs to be changed in the future.