Why does the stainless steel braided casing have broken wires?

Stainless steel braided casing is widely used as a product that is widely known to the public, but I don`t know if you have experienced the phenomenon of broken wires in stainless steel braided casings. If the stainless steel braided casings we use have broken wires, There may not be any major problems in the near future, but as time goes by, adverse reactions will slowly appear. So what is the reason for the broken wires of the Stainless Steel braided sleeve.

1. If the size adjustment of the mold on the machine is wrong, the proportion of the normal compression ratio will be confused during the weaving process, resulting in broken threads. The solution is to ensure the absolute size of the mold on the machine.
Round Stainless Steel Braided Sleeve
2. The oil or water is cut off during the mold loading process, causing the mold to run a large hole distance in a short time, the compression ratio is out of balance, and the wire is broken. The solution is to add lubricant to each mold in time to ensure its cooling and lubrication.
3. When wicker threads appear during the weaving process, the stainless steel braided casing will be broken if the take-up speed is too fast. The only solution is to replace the mold to ensure that the phenomenon of wicker threads will not happen again.
4. A certain piece of natural road consumption in the mold is too fast, causing the front and rear compression ratio of the stainless steel Braided Sleeve to be out of balance, and broken wires appear, mainly manifested as several broken wires at one position. The solution is to replace the mold and adjust the front and rear compression ratio until normal.