Common problems in the use of Nylon Braided Sleeve

November 01, 2024

The bearing capacity of Nylon Braided Sleeve depends on the inner layer and the middle braided layer. If it is not properly installed during the use process, it will cause the air to penetrate into the inner layer between the inner layer and the outer layer. At this time, the hose mainly relies on the outer layer to bear the force, which will greatly reduce the bearing capacity of the Nylon Braided Sleeve manufacturer and cause the pipe body to crack.

If the Nylon Braided Sleeve uses a jacket-type quick connector, or a threaded connector/throat clamp with burrs or burrs, it is likely to cause the Nylon Braided Sleeve pipe body to delaminate and crack.

We can see that when the jacket-type quick connector is used to insert the Nylon Braided Sleeve, it mainly relies on the outer layer to seal. In this case, the gas is easy to penetrate from the inner layer, causing the outer layer to explode and the pipe body to delaminate.

Try to avoid the use of jacket-type quick connectors that rely on the outer layer to seal the Nylon Braided Sleeve.

If the outer layer of the Nylon Braided Sleeve is found to be cracked or the pipe body is delaminated during the use process, please check whether the jacket-type quick connector is used and whether the connector and the throat clamp have burrs and burrs.

If you want to use a jacket-type quick connector, it is recommended to use a single-sided double fish head PU tube if the working pressure allows.

1. When inserting the threaded connector, please do not apply vegetable oil or heat it with fire on the threaded connector of the hose. Please use a small amount of warm water to warm the hose before installation.

2. Please use a connector that is suitable for the hose specification, cut the wound and insert the hose as much as possible. Be careful not to use connectors with burrs, burrs, scars, or rust.

3. Please use a hose clamp of appropriate size, and do not use a fake hose clamp with burrs and burrs.

4. Avoid using steel wire instead of a hose clamp to avoid over-tightening the hose.

5. Do not use a jacket-type quick connector with a Nylon Braided Sleeve, otherwise it is easy to cause the hose to delaminate and crack.

Author:

Mr. hyhcablesleeve

E-mail:

hyhcablesleeve@gmail.com

Phone/WhatsApp:

++86 13728648995