What should I do if the Nylon Braided Sleeve is damaged from the edge and center?

There are generally two situations that damage the Nylon Braided Sleeve. One is that the material strength is very high, and the friction caused to the Nylon Braided Sleeve is relatively large, causing the Nylon Braided Sleeve to be damaged. There is also a kind of friction between the mesh and the Nylon Braided Sleeve that will cause the Nylon Braided Sleeve manufacturer to have thousands of small holes, causing the Nylon Braided Sleeve to be damaged from the edge and center.

1. The mesh number of the Nylon Braided Sleeve is determined by the diameter and the wire pitch. Now we need to determine that the wire pitch can be increased when the diameter remains unchanged, and the other is to use a high-strength Nylon Braided Sleeve so that the Nylon Braided Sleeve will not easily wear the screen in a short time.

2. It will happen in the process of filtering high-fine viscous slurry. It is common for everyone to damage the Nylon Braided Sleeve from the edge and the center during the process of screening porcelain slurry. Because the mesh number of the Nylon Braided Sleeve used for filtering porcelain slurry is very high and the price is too expensive, saving Nylon Braided Sleeve is to save product costs.

We added rubber pads to the edge of the screen frame to make the friction of the Nylon Braided Sleeve at the edge softer. In addition, the center of the general Nylon Braided Sleeve has a large bearing capacity, that is, the friction between the Nylon Braided Sleeve in the center and the lining net is more serious, and the screening effect of this part is just poor, so we also use rubber pads to separate the 5cm in the center of the Nylon Braided Sleeve. In this way, the forced friction between the Nylon Braided Sleeve and the lining net and the edge of the Nylon Braided Sleeve is reduced. Experiments have shown that the service life of the Nylon Braided Sleeve can be increased by 3 to 5 times the original.