Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
There are always some situations in the production and molding of Automotive Wiring Harness Protection Sleeve. For example, sometimes the size of the Automotive Wiring Harness Protection Sleeve is larger or smaller than the size on the design drawing. What is the reason? It should be known that if the size of the Automotive Wiring Harness Protection Sleeve after molding is different from the size of the design and production, the produced products can only be treated as defective products and scrapped. Therefore, manufacturers of Automotive Wiring Harness Protection Sleeve will pay more attention to this aspect when producing. , the following editor will introduce the cause of the error and the solution?
First of all, the temperature of the product molding mold is too low, and the fluidity of the raw materials is relatively poor, resulting in an error in the product molding size and expectations! Therefore, the temperature of the mold should be increased when the product is formed. It should be known that the higher the temperature of the forming mold, the better the Cable Sleeve can be formed according to the forming mold due to the temperature, and the fluidity of the raw materials will be close to the mold. When moving in the mold, there will be no errors.
October 16, 2024
October 15, 2024
October 16, 2024
October 15, 2024
Email to this supplier
October 16, 2024
October 15, 2024
October 16, 2024
October 15, 2024
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.