How is Tinned Copper Braided Sleeve used?

Tinned Copper braided sleeve is very common, the production process is: rubber refining - extrusion - vulcanization setting coil (or cutting packaging) process; and the snap-on Tinned Copper Braided Sleeve will be in the original tinned Improvements are made on copper braided sleeves. Because the Tinned Copper Braided Sleeve mold is special, the buckle design is a concave-convex groove. So this is different from ordinary tinned copper braided casing. In addition, the ordinary Tinned Copper Braided Sleeve can play the role of insulation protection by wearing the sleeve. So how should this knotted Tinned Copper Braided Sleeve be installed and used, what function and effect does it play?

First, prepare the materials and necessary tools. Take the Cable Sleeve as a cross section. The specification is slightly larger than the outer diameter of the bare wire, and 2-4mm is slightly larger than the outer diameter of the bare wire. It is easy to get stuck when working at high altitudes. If it is too small or too tight, it may not be tight. , the time will also drop; but not too big, too big, the friction mouth may loosen and fall off when blowing and swinging at high altitude impact;
Second, check for corrosion on the bare wire surface. After wiping the stains on the surface, the corrosion of the bare wires should be wiped with paper and alcohol. Here is the demo. If you install and operate directly at high altitude, you only need to remove the external force to reduce installation time, difficulty and risk.
Finally, after the wire is cleaned, the Cable Sleeve is directly glued to the bare wire, and then attached to the uniform stain, coated with a special adhesive for the insulating sheath, and then lightly cling to the opening of the buckle, about 7 to 8 meters so that all overhead lines are covered.
Generally speaking, the insulation treatment of bare conductors has many uses, generally only the following points:
1. Protect the bare conductor itself: When other foreign objects are horizontally overlapped outdoors for a long time, short-circuit power failure may occur.
2. Protection of surrounding objects: such as high-voltage wires passing through crowded areas, house roofs, fishing and power protection on fish ponds, crossing tunnels, pulling barbed wire orchards, etc., must install button-type insulating sleeves to reduce the distance of voltage arc discharge. security to a certain extent.