How to Make a Neoprene Zipper Cable Sleeve

The general Neoprene Zipper Cable Sleeve itself will have some smell, most of these odors come from the Neoprene Zipper Cable Sleeve itself and some Cable Sleeve agent. It is very difficult to be completely odorless, so is there any way to reduce the odor of the finished Neoprene Zipper Cable Sleeve? The editor summarizes the following methods for reference.

Low odor can't solve the problem from the glue alone, the key is material selection.
1. It is easier to use EPDM, but it must be genuine glue, using the metallocene method, with an ENB content of about 9.
2. The selection of compounding agent is the key to success. Special attention is paid to carbon black, which is generally ignored by people. Low-quality carbon black has too much residual hydrogen, which is not good news for the smell.
3. For the Cable Sleeve system, the amount of accelerator and Cable Sleeve agent should be just enough, and the sulfur will grow at low temperature. The degree of cross-linking must allow the reaction of the promoting system to be complete.
4. It is advisable to use secondary Cable Sleeve, no matter it is a sulfur Cable Sleeve system or a peroxide system, the secondary Cable Sleeve is good for removing odor.
Therefore, it is very important to choose the right rubber, and the Cable Sleeve system should also pay attention to it. Some smelly accelerators cannot be used, and /STT/D can be used together, and white petroleum jelly can be used as a soft and slippery agent.