Next, the editor will give you a brief introduction.
1. Clean the pasted surface to make it clean, smooth, flat and dry.
2. Measure the height of doors and windows, and cut off the PP self-wrapping woven sleeve with scissors according to the height.
3. Remove a small piece of protective paper pasted on the back, install the PP self-wrapping woven sleeve in the correct position and press it tightly, aligning with the upper edge as much as possible.
4. Uncover the protective paper on the back continuously, so that the
PP Self Wrap Braided Sleeve extends downward along the frame, and press it continuously, be careful not to stretch it.
5. Install the horizontal
PP Self wrap braided sleeve in the same step, pay attention to the coincidence of the corner joints, and there should be no gaps between the joints.
6. Note: The installation position of the
Pp Self Wrap Braided Sleeve at the hinge.
How to prevent PP Self Wrap
Braided Sleeve from falling off:
1. Before the glass is installed, the debris in the tank should be carefully removed, such as mortar, brick chips, wood blocks, etc. When the glass is placed, it should be carefully centered to ensure that the space on both sides is even and fixed in time to prevent bumping, displacement, and violation of the groove. end.
2. PP Self Wrap Braided Sleeve should not be pulled too tight. The blanking length is 20-30mm longer than the assembly length. When installing the device, it should be inlaid in place, the surface should be straight, the glass and the glass groove should be in close contact, so that the force around the glass is uniform, and the rubber strips at the corners should be cut off on the slope and bonded firmly at the break.
3. When filling the fixed glass with the
Cable Sleeve, apply the PP Self Wrap Braided Sleeve to squeeze the glass to leave room for injection, and the injection depth should not be less than 5 mm. The glass should not vibrate until it has cured.