What will happen if the Automotive Wiring Harness Protection Sleeve is over-knitted?

The most important process in the production of Automotive Wiring Harness Protection Sleeve is knitting sleeves. The quality of the product is related to the length of time it takes to knit the sleeves. The editor below will talk about what will happen if the Automotive Wiring Harness Protection Sleeve is over-knitted and what causes it. What happens if the Cable Sleeve is severely over Braided Sleeve.

Nowadays, the process of plastic-coating steam Braided Sleeve slowly heats up, and the canning volume accounts for 85% of the total volume. Raise the temperature for 2 and a half hours, and then knit the sleeves at 151 degrees for 2 and a half hours. Will there be any quality problems if this is done? If you have experience in this area, please share it, or you can help me analyze it.
It is necessary to have a certain ability to foresee problems that may arise in the product. The problem now is that the colored Cable Sleeve are seriously discolored. Different tubes have different degrees of darkening, almost one color at a time. Some tubes have light-colored speckled stripes in the middle, and after sanding off the surface, the inside is the same color. Something terrible could happen.
Raise the temperature for 2 and a half hours, and then knit the sleeves at 151 degrees for two and a half hours. What kind of rubber is this made of? Ordinary rubber should probably be scrapped. The knitting sleeves do take a long enough time. The poster peeled off the cable casing. The tensile properties of the pieces are measured, and by the way, scrapping is not possible, lifespan is damaged, and serious quality problems are unavoidable.
When making cable casings, I have seen Braided Sleeve that heat up for 45 minutes and last for an hour and a half, but they feel a bit long. The heating time is so long, it should be that the tonnage of the boiler is too small and the gas production is insufficient, which will affect the product quality. Rigid core Cable Sleeve, slim Braided Sleeve can. While the equipment is being installed, workers are asked to step on it. It is full of equipment and heat transfer is also a problem. Uneven Braided Sleeve will definitely appear. The outermost layer is 100% severely over-sulfurized, and the middle cable casing has a relatively light degree of sulfur. It may be just right, it may be over-sulfurized, or it may be a little short.
Titanium dioxide 6-10 is acceptable, but more is a waste and the process will not be very good. Use other fillers to replace them if they can be used. If not, use less. Then add titanium dioxide for more than 20 minutes, and it will definitely be super white.