Which is better, stainless steel braided casing or bellows

Braided casing is a very commonly used component in the industrial field. Many people have doubts about this item. For the recent common problems: Is the metal casing better braided or stainless steel bellows? The editor makes the following three Point summary, for selection reference.

1. Casing composition distinction

Stainless steel braided casing: wire, inner tube, steel sleeve, core, gasket, nut.

Corrugated pipe: hexagonal cap, pipe body, gasket, Stainless Steel braided sleeve.

2. Differences in the scope of use of casing

Braided pipe: It is mainly used to connect the angle valve at the water inlet with the basin faucet, kitchen faucet, vertical bathtub faucet, water heater, central air conditioner, and toilet, and form a drainage pipe for water supply channels.

Bellows: Used for the transmission of high-temperature liquids and gases, such as water heater inlet pipes, medium gas delivery pipes, faucet water inlet pipes, etc. For areas with poor water quality, bellows can be preferred for water heater connection pipes.

3. Manufacturing process and performance distinction of casing

Stainless steel braided casing: It is made of 6 strands of 304 stainless steel. The flexibility of the whole pipe is relatively good, and the explosion-proof effect is good. However, compared with the bellows, the diameter is smaller and the water flow is small.

Stainless steel corrugated pipe: The pipe body is uneven. There is only one outer pipe and no inner pipe. fracture.

Manufacturers of Stainless Steel Braided Sleeve have expanded the application of technological innovations in different fields to the field of Stainless Steel Braided Sleeve, and nanotechnology and thermoplastic rubber technology have released relatively common applications of Stainless Steel Braided Sleeve.
Because the stainless steel braided sleeve has a short stable time and a high melting point, a large amount of sliding friction and heat should be used in the temperature range of the melting point, and the small plastic injection system and products should not be lower than 2/3 of the amount introduced into the machine. According to the PET stainless steel braided sleeve According to the relevant requirements of the pipe, the PET melting system designed and developed in recent years has been mass-produced, and the clamping capacity exceeds 6300t/m2.