Why use eager cutting process for PP Velcro Braided Sleeve?

Everyone often encounters a problem when cutting PP Velcro Braided Sleeve, that is, after cutting Pp Velcro Braided Sleeve, there will be loose threads and fluffy phenomenon. usage method.

A hot blade is simply a metal strip that, when heated high enough, will melt the Braided Sleeve. It not only reduces the length required for PP zipper braided sleeves to melt, but also incorporates cuts to prevent loss caused by loose yarns during installation and use; usually, a hot knife has a blade connected to 2 transformers, when current As the blade is passed, the resistance heats it to the desired temperature; the first time the hot knife is used, the blade is mounted on the post and tightened. When the knife is first turned on, there may be some smoke from the lubricating oil on the blade heating up, nothing to worry about. After using the hot knife for about 20 minutes, turn it off; after cooling, check whether the screws are tightened, a high-quality hot knife can provide more than 10,000 times of trouble-free use.
Before using the hot knife, it is necessary to measure the length of the braided sleeve and keep the sleeve in a relaxed state. The most accurate method is to measure the expansion and contraction ratio of the sleeve in actual application. In the use of large wire harnesses and connectors, there will be some reinforced and encrypted braided sleeves whose expansion rate exceeds the normal expansion ratio. Remember to mark the cutting line with a marker pen after completing the stretch ratio test. When cutting Braided Sleeving using the heat cutting process, be sure to work in a well-ventilated working environment, avoid inhaling exhaust fumes, and be careful to avoid burns. After cutting the PP Zipper Braided Sleeve, you can use a cone-shaped hollow tool such as a funnel to help thread it into the wire harness, so that the braided sleeve can easily slide through the plug or connector, just put the funnel at the flared end while threading it down Expand until the wires are exposed, then take out the funnel inside the network management, and finally smooth the network management.
The eager cutting process can avoid the generation of loose yarn and greatly reduce the production loss. At present, most of the braided sleeve manufacturers can provide free eager service. For the users of PP zipper knitted sleeves who do not have the eager conditions, please be sure to mark it when purchasing Is eager service required.